---
url: /trade-config/loss-streak-risk-reduction.md
description: >-
  An experimental, per-channel control ("Smaller size after losses") that
  automatically sizes your trades down after consecutive losses and restores
  them after a win, so a cold streak costs less.
---

# Loss-Streak Risk Reduction

Loss-Streak Risk Reduction is an experimental control, called **Smaller size after losses** on a channel's page, that shrinks your position size automatically when a channel is on a losing run, then restores it once the channel wins again. The idea is simple: a bad streak should cost you less than a good one earns, without you having to babysit the sizing by hand. It works per channel *and* per account, so a cold streak on one channel never touches your sizing anywhere else.

## Where to find it

It lives on the channel, not in Settings: open the channel, go to **Setup**, and look under **Orders & position size** for the **Smaller size after losses** card (it carries an **Experimental** badge, and a note that it was called "Loss streak sizing"). There is one block per account the channel runs on, each with its own switch, so you can turn it on for a demo account and leave it off on a live one. When it is on and a streak is running, the block shows a chip such as "Now at 50% size · 1-loss streak". Settings only points to it: its **Set on each channel** box lists "loss-streak sizing".

::: warning Experimental
This is an experimental control, off by default. Test it on a demo account before using it on live capital — behavior and defaults may change.
:::

## What it does

Every time a trade on a channel closes at a **loss**, TTMT applies a **risk multiplier** — a fraction of your normal size — to the *next* trade on that same channel and account. Stay in the red and the multiplier keeps shrinking; win, and it snaps back to full size. The multiplier only ever scales the size *down* from your normal risk; it never sizes you up.

Because the scope is **per channel × account**, each channel carries its own streak on each account:

* A losing run on your gold channel sizes down only that channel's gold trades, on that account.
* The same channel on a different account tracks its own separate streak.
* Every other channel keeps trading at full size.

## How the multiplier moves

The **Size curve** has two choices for how the multiplier shrinks after a loss:

| Curve | After each closed loss |
|---|---|
| **Compounding** | "Halves again on every consecutive loss" — 100% → 50% → 25% → 12.5% … |
| **Fixed 50%** | "Drops to 50% once, holds until a win" — the multiplier drops to a flat **50%** and stays there while the streak continues |

A **closed profit restores** the multiplier back to full size — one winning trade ends the reduction, whichever curve you use.

### The floor

**Never smaller than** sets a **floor** the multiplier never falls below. Three choices are offered — **50%**, **25%**, and **12.5%** — and if a floor can't be resolved for any reason the system uses **12.5%** as the fallback. The floor stops Compounding from shrinking your trades into nothing on a long streak: once it reaches the floor, it stays there until a win resets it. With **Fixed 50%** the floor is shown but not used ("Not used with Fixed 50%: size never goes below 50%."). The broker's minimum lot always applies on top.

::: info Example — a compounding streak
You run Compounding with a **25%** floor on a channel. Three losses in a row take the multiplier 100% → 50% → 25%, where the floor holds it. The next trade is sized at a quarter of normal. Then a winner closes — the multiplier snaps back to 100% and the channel trades full-size again.
:::

### Also reduce while a losing trade is open

Under **More settings (1)**, the switch **Also reduce while a losing trade is open** makes the next trade smaller before the streak has been confirmed by a close. It uses live prices and counts a trade as losing once it is about 20% of the way to its stop. The preview and the backtest do not include it.

## When the streak resets

**Back to full size** has two choices:

| Reset | The multiplier resets on |
|---|---|
| **Daily + on a win** | A win **or** the daily 5 PM ET session boundary |
| **Only on a win** | A win only |

**Daily + on a win** is the more forgiving of the two: even without a win, the streak clears at the daily 5 PM ET rollover, so yesterday's cold run doesn't follow you into a new session. **Only on a win** carries the streak across days until the channel actually wins — stricter, and better suited to a channel you want held on a tight leash until it proves itself again.

## Where it sits in your sizing

Loss-Streak Risk Reduction is the **last** sizing step, applied on top of everything else:

1. Your normal sizing runs first — fixed lots, % of balance or a fixed amount, with the increase for a signal marked high risk where it applies.
2. The loss-streak multiplier scales that result down.
3. Finally, the broker's **minimum-lot** rules clamp the outcome, so a heavily reduced trade never drops below a size your broker can actually place.

Because the broker minimum-lot clamp comes last, on very small accounts or very small lot sizes a reduced trade may land at your broker's minimum rather than the exact multiplied figure. That is expected — the clamp keeps the order fillable.

::: info What counts toward the streak
The streak is built from **closed** trades on the channel and account. A losing trade that you later soft-delete still counts toward the streak history — removing it from your logs does not erase it from the streak. If the multiplier can't be resolved for any reason, TTMT falls back to a **neutral multiplier of 1** (full size), so a lookup failure never silently changes your risk.
:::

## Backtesting it before you turn it on

Because this control is experimental, TTMT lets you **backtest** it against a channel's past trades before you commit. The backtest replays the channel's closed history on that account through your chosen curve and floor and shows what your sizing *would* have been. On a wide screen the backtest panel sits beside the controls.

* The backtest needs at least **10 trades** of history to run — a channel with fewer closed trades can't be evaluated.
* The result is a **historical illustration, not a projection**. It shows how the rule would have behaved on trades that already happened; it does not predict future performance.

## Reading it in the Signal Tester

When you run a signal through the [Signal Tester](/dashboard/signal-tester), the sizing it reports is the **unscaled baseline** — your normal size *before* any loss-streak multiplier. The tester deliberately shows the baseline so you can see your configured sizing clearly; the live multiplier only ever applies to real, sequential trades on the channel.

## When to use it

Loss-Streak Risk Reduction suits channels that go through defined hot and cold spells — where a losing run tends to cluster and a win genuinely marks a turn. It contains the damage of a cold streak automatically, then gets out of the way once the channel recovers.

It is less useful on a channel whose results are effectively random trade to trade, where a past loss says nothing about the next trade. And because it is experimental, treat it as something to trial on a demo account first — watch a few streaks play out in the logs, confirm the sizing moves the way you expect, and only then consider it on live capital.

## Related pages

* [Order Setup](/trade-config/order-setup) — the base sizing this control scales down
* [Risk Management](/core-concepts/risk-management) — how position size is worked out and the account-only daily limits
* [Channel Settings](/channels/channel-settings) — the channel's Setup page, where this control lives
* [Signal Tester](/dashboard/signal-tester) — shows the unscaled baseline size
* [Trade Preview](/trade-config/trade-preview) — see your base sizing on a sample trade
